问题描述：只要将此三个文件拷贝到:
"Unigraphics NX 2.0\UGII\menus"下把原来的文件覆盖掉即可.然后再运行UG 2.0,使
用起来将会是很方便的.现传上来与大家共享!
IMPORT_PART Ctrl Shift O
IMPORT_PARASOLID C
回答：只要将此三个文件拷贝到:
"Unigraphics NX 2.0\UGII\menus"下把原来的文件覆盖掉即可.然后再运行UG 2.0,使
用起来将会是很方便的.现传上来与大家共享!
IMPORT_PART Ctrl Shift O
IMPORT_PARASOLID Ctrl Alt P
IMPORT_IGES Shift Ctrl I
IMPORT_DXF/DWG Shift Ctrl D
EXPORT_PART Shift Alt P
EXPORT_PARASOLID Shift Alt S
EXPORT_IGES Shift Ctrl S
EXPORT_UGTO2D Shift Ctrl E
TRANSFORM Ctrl T
OBJECT_DISPLAY Ctrl J
UG_VIEW_SAVE_AS Alt V
UG_LAYER_SETTINGS Ctrl L
UG_LAYER_VIEW Ctrl Shift V
UG_LAYER_MOVE Ctrl Shift X
UG_LAYER_COPY Ctrl Shift C
UG_LAYOUT_NEW Ctrl Shift N
UG_LAYOUT_OPEN Ctrl Shift O
UG_TOOLBOX_EXPRESSION Ctrl E
UG_MACRO_RECORD Ctrl Shift R
UG_MACRO_PLAYBACK Ctrl Shift P
UG_MACRO_STEP Ctrl Shift S
UG_MODELING_EDIT_FACE Shift F
EDIT_FEATURE_PARAMETERS Shift E
REMOVE_PARAMETERS Shift P
EDIT_FF_ISO_TRIM Shift T
EDIT_FF_BOUNDARY Ctrl Alt B
EXTRUDED_FEATURE Alt E
HOLE_FEATURE Alt H
EXTRACT_FEATURE Alt X
BLOCK_FEATURE Shift B
CYLINDER_FEATURE Shift Y
CONE_FEATURE Shift C
SPHERE_FEATURE Shift S
TAPER_FEATURE Alt P
BLEND_FEATURE Alt R
CHAMFER_FEATURE Alt K
SEW_FEATURE Alt W
OFFSET_FEATURE Alt O
SCALE_FEATURE Alt A
TRIM_FEATURE Alt T
SPLIT_FEATURE Alt L
UNITE_FEATURE Alt U
SUBTRACT_FEATURE Alt B
INTERSECT_FEATURE Alt I
SWEPT Shift Alt W
UG_VIEW_POPUP_REFRESH F5
UG_VIEW_POPUP_FIT Ctrl F
UG_VIEW_POPUP_ZOOM F6
ZOOM_IN_OUT F8
ROTATE F7
UG_VIEW_POPUP_UPDATE Shift A
UG_VIEW_SNAP_VIEW F9
UG_VIEW_WIREFRAME F10
UG_VIEW_FULLY_SHADED F11
PARTIALLY_SHADED F12
|
|
